I bought STEVAL-MKSBOX1V1 of ST and wanted to write my own library to create a BLE application.
The BLE module on board is SPBTLE-1S which mounts BlueNRG-1, I wrote my own firmware in order to communicate using SPI protocol.
After resetting the module using the pin I send a read request from MCU to the BLE module,
HAL_GPIO_WritePin(SPI1_CS_GPIO_Port,SPI1_CS_Pin,0);
HAL_SPI_TransmitReceive(&hspi2,tx,rx,5,1);
HAL_GPIO_WritePin(SPI1_CS_GPIO_Port,SPI1_CS_Pin,1);
I send:
{0x0b,0x00,0x00,0x00,0x00}
I get:
{0xff,0x08,0x00,0x06,0x00}
So apparently nothing good because the first byte is 0xff and not 0x02 (right?), but the 4th bit(0x06) should indicate the amount of data inside the read buffer.
If I read 6 bytes I get
{0x04,0xff,0x03,0x01,0x00,0x01}
And according to AN4494 It is exactly what I should read after the reset event on the module.
Then my question is why I keep getting {0xff,0x08,0x00,0x06,0x00} and not something like {0x02,....}?
Is there anything related to BlueNRG1 that is different from BlueNRG2? (It is so hard to find good documentation)
If anyone has some experience on SPI communication with this module I would like to have a bit of consulting.
Thanks in advance
