debugging - Stop and continue execution from debugger possible?

Question

Is there any way to stop the execution of a matlab program from the debugger like ctrl+c does, but then being able to continue execution (like you can in say c#)?

If not, is there any better way to workaround this other than trying to pre-emptively set break points or dbstop statements in your matlab code?

I would like to be able to interrupt a long running simulation to look at the current state and then continue the simulation.

The two options I'm currently using/considering are

1. dbstop commands (or (conditional) breakpoints) in the code. Drawback is that sometimes I don't want to stop the simulation for a few hours, sometimes want to stop after only a few seconds (and I don't necessarily know that in advance) and this doesn't work well with this approach: If I set the break condition to break every 5 minutes, I can't leave matlab running for hours without interaction. If I set the condition to higher, I have to wait too long for the condition to hit.

2. include code to save the workspace every few seconds/minutes and import the workspace into a second matlab instance. Drawback is that this is a huge hassle and also doesn't necessarily allows me to resume the simulation with the state of the saved workspace then step through the code for a few iterations.

I'm hoping there is a better solution than either of the 2. Thanks for any advice!

Edit: I think what I'm going to do is write simple matlab function that checks an environment variable or a file on disk every iteration and calls dbstop if I set a flag in this file or env. This way I can control when (and if needed which of several) the breakpoint hits from outside matlab by editing the file. Messy, but should work.

Answer 1

This is not necessarily the best way, but you could simulate a file-based signal/interrupt framework. It could be done by checking every once in a while inside the long simulation loop for the existence of a specific file. If it does, you enter interactive mode using the keyboard command.

Something along the lines:

CHECK_EVERY = 10;    %# like a polling rate

tic
i = 1;               %# loop counter
while true           %# long running loop
    if rem(i,CHECK_EVERY) == 0 && exist('debug.txt','file')
        fprintf('%f seconds since last time.
', toc)
        keyboard
        tic
    end

    %# ... long calculations ...    

    i = i + 1;
end

You would run your simulation as usual. When you would like to step in the code, simply create a file debug.txt (manually that is), and the execution will halt and you get the prompt:

2.803095 seconds since last time.
K>> 

You could then inspect your variables as usual... To continue, simply run return (dont forget to temporarily rename or remove the file). In order to exit, use dbquit

---

EDIT: Just occurred to me, instead of checking for files, an easier solution would be to use a dummy figure as the flag (as long as the figure is open, keep running).

hFig = figure; drawnow
while true
    if ~ishandle(hFig)
        keyboard
        hFig = figure; drawnow
    end

    %# ...
    pause(0.5)
end