arm - What is the difference between =label (equals sign) and [label] (brackets) in ARMv6 assembly?

Question

I'm following along with the Baking Pi course from Cambridge University, in which a simple operating system is built in the ARMv6 instruction set, targeting the Raspberry Pi.

We've been using two ways of loading data into registers via the ldr instruction so far and I realize now that I'm using them together, I don't fully understand what they both do.

So I've used things like ldr r0,=0x20200000, which I actually understood as "read the data stored at the memory location 0x20200000 into register r0.

Then I've used things like:

ldr r0,[r1,#4]

Which I've understood as being "read the data stored at the memory address pointed to by r1, at an offset of 4 bytes, into register r0".

Then I encounter this:

ldr r0,=pattern
ldr r0,[r0]

pattern here is a .int in the .data section (a bitmap representing a sequence of on/off states for an LED). I realize upon reading this, that my previous understanding of =foo must be wrong, otherwise both of the above instructions would do the same thing.

Is the =x syntax basically more like a pointer in C, while the [x] syntax is as if the memory that is being pointed to by x is actually read?

Let's say ptr in the C below is an int*, do my comments thinking about equivalent assembly (conceptually, not literally) make any sense?

r0 = ptr;     /* equivalent to: ldr r0,=ptr     */
r0 = *ptr;    /* equivalent to: ldr r0,[ptr]    */
r0 = *(ptr+4) /* equivalent to: ldr r0,[ptr,#4] */

Answer 1

ldr r0,=something
...
something:

means load the address of the label something into the register r0. The assembler then adds a word somewhere in reach of the ldr instruction and replaces it with a

ldr r0,[pc,#offset]

instruction

So this shortcut

ldr r0,=0x12345678

means load 0x12345678 into r0.

being mostly fixed length instructions, you cant load a full 32 bit immediate into a register in one instruction, it can take a number of instructions to completely load a register with a 32 bit number. Depends heavily on the number. For example

ldr r0,=0x00010000

will get replaced by the gnu assembler with a single instruction mov r0,#0x00010000 if it is an ARM instruction, for a thumb instruction though it may still have to be ldr r0,[pc,#offset]

These ldr rd,=things are a shortcut, pseudo instructions, not real.

ldr rd,[rm,#offset]
ldr rd,[rm,rn]

are real instructions and mean read from memory at address rm+offset or rm+rn and take the value read and put it in the register rd

the =something is more like &something in C.

unsigned int something;
unsigned int r0;
unsigned int r1;

r0 = &something;
r1 = *(unsigned int *)r0;

and in assembly

something:
    .word 0

ldr r0,=something
ldr r1,[r0]