Welcome to OGeek Q&A Community for programmer and developer-Open, Learning and Share
Welcome To Ask or Share your Answers For Others

Categories

0 votes
418 views
in Technique[技术] by (71.8m points)

c - while(1) .. break instead of goto

I found the following code in a C program:

while (1)
{
    do_something();
    if (was_an_error()) break;

     do_something_else();
     if (was_an_error()) break;

     [...]

     break;
}
[cleanup code]

Here while(1) is used as local emulation of "finally". You can also write this using gotos:

do_something()
if (was_an_error()) goto out;

do_something_else()
if (was_an_error()) goto out;

[...]
out:
[cleanup code]

I thought the goto solution is a usual idiom. I have seen several occurrences of this idiom in the kernel sources and it is also mentioned in Diomidis Spinellis' "Code Reading" book.

My question is: What solution is better? Is there any specific reason to use the while(1) solution?

Question 943826 doesn't answer my question.

See Question&Answers more detail:os

与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
Welcome To Ask or Share your Answers For Others

1 Reply

0 votes
by (71.8m points)

The seemingly universal revultion to GOTO is largely due to Edsger Dijkstra's letter "Go To Statement Considered Harmful".

If you are determined not to use goto, something like

do {
    ...
while(0);

is probably safer than while(1) { ... } since it guarantees that you will not inadvertently loop (and if you are inadvertently looping, with while(1) you are probably inadvertently looping infinitely).

The one advantage that (ab)using do/break/while or while/break for this purpose has over goto is that you are guaranteed not to be jumping above the construct -- goto can be used to jump to a label earlier within the same function.

The disadvantage that do/break/while etc. have over goto is that you are limited to one exit point (immediately after the loop). In some cases you might need a staged cleanup: e.g., when you open a file handle, malloc some memory, read from the file... if the read fails, you need to clean up the malloc. If the malloc fails, you don't need to clean it up, but you still need to clean up the file handle. With goto, you can have one label per stage of cleanup and jump to precisely the right point depending on where your error occurred.

In my opinion blindly avoiding GOTO because of the prevalent hatred of it is more damaging than carefully reasoning out a case for its use on a case-by-case basis. A rule of thumb I use is "does the Linux kernel do it? If so, it can't be that bad". Substitute linux kernel with any other good example of modern software engineering.


与恶龙缠斗过久,自身亦成为恶龙;凝视深渊过久,深渊将回以凝视…
OGeek|极客中国-欢迎来到极客的世界,一个免费开放的程序员编程交流平台!开放,进步,分享!让技术改变生活,让极客改变未来! Welcome to OGeek Q&A Community for programmer and developer-Open, Learning and Share
Click Here to Ask a Question

...